Propeller 1

Propeller 1 discussion for all applications, hobby or commercial.

Discussion	Started By	Replies	Views	Most Recent
Sharing VGA and TV output, and runtime output autodetection	AntoineDoinel 2011-05-10 17:08	11	2.6K	Ariba 2011-05-12 18:44
Different VGA Font sizes	babinda01 2011-05-12 17:28	3	1.1K	babinda01 2011-05-12 18:20
Sneak Peek on Parallax's $20 Propeller Board (fixed) 1 2 3 4	Oldbitcollector (Jeff) 2011-04-30 17:04	109	10.3K	Sapieha 2011-05-12 14:20
Embedded Basic Requirements (was Prop II: Too little, too late ???) 1 2 3	David Betz 2011-05-11 07:44	64	3.3K	jazzed 2011-05-12 10:21
Reading voltage at I/O pin	garylake 2010-12-24 10:12	13	2K	M. K. Borri 2011-05-12 09:17
Binary Division and Multiplication	SailerMan 2011-05-11 19:23	5	925	prof_braino 2011-05-12 06:08
ZOG with the JCACHE interface	David Betz 2011-05-12 05:30	2	375	Heater. 2011-05-12 05:56
Are Current limiting resistors required for TWO Props via Serial Coms?	DavidM 2011-05-10 22:29	7	1.1K	DavidM 2011-05-12 02:19
$3.00 programming cable hack? 1 2 3	Oldbitcollector (Jeff) 2009-10-05 14:01	77	19.7K	M. K. Borri 2011-05-12 01:37
Stingray programming troubles	2pietjuh2 2011-05-09 02:36	10	1.1K	2pietjuh2 2011-05-12 00:05
Assembler - strange behaviour	GrahamS 2011-05-11 11:03	8	523	GrahamS 2011-05-12 00:02
Suggested standard for LOCK's 1 2	Bill Henning 2011-05-11 07:21	32	3K	Dr_Acula 2011-05-11 17:29
New C3 game.. "SpaceACE!"	Ravenkallen 2011-05-05 19:21	13	2.3K	Ahle2 2011-05-11 10:08
Two Props Communicating?	Kirk Fraser 2011-05-10 22:00	7	536	th3jester 2011-05-11 09:48
Beginner Propeller Help Cannot Set Pins	dtreth 2011-05-11 02:17	9	678	prof_braino 2011-05-11 07:21
Controllers: PID, Sliding Mode, Root Locus, Ect...	th3jester 2011-05-10 18:27	3	726	th3jester 2011-05-10 19:16
"slaving" two Props together	davejames 2011-05-05 17:00	30	2.2K	kuroneko 2011-05-10 18:52
Using Boost Regulator and Disabling Brown Out Reset Closed	william chan 2011-05-02 21:31	4	205	william chan 2011-05-02 21:31
Using Boost Regulator and Disabling Brown Out Reset	william chan 2011-05-02 21:31	4	1.4K	Daniel Harris 2011-05-10 16:12
What two values for VGA R-2R resistor ladder?	tonyp12 2011-05-10 12:17	6	5.8K	tonyp12 2011-05-10 14:23
Quickstart Chips	wjsteele 2011-05-09 19:15	3	1K	wjsteele 2011-05-10 11:17
Question about Propeller RTC emulator?	Ravenkallen 2011-05-07 21:46	16	2.2K	Phil Pilgrim (PhiPi) 2011-05-10 07:56
Hiring Eagle Help	JohnC 2011-05-10 07:27	1	297	JohnC 2011-05-10 07:27
Looking for feedback/suggestions (New User)	MyITGuy 2011-05-07 17:11	5	477	MyITGuy 2011-05-09 16:41
Programing only using the serial port	shaunak 2011-05-09 11:51	6	812	shaunak 2011-05-09 12:31
Datalogging at higher speeds 1 2	-GRIMM- 2011-03-10 09:04	58	6K	-GRIMM- 2011-05-09 09:14
Is it possible/practical to run sections of a single DAT section in separate cogs?	Octahedron 2011-05-08 10:41	7	379	davidsaunders 2011-05-09 08:18
Propeller mentioned in Digi-Key TechZone	ctwardell 2011-05-02 17:13	4	1.1K	prof_braino 2011-05-09 06:54
MuAmi Amiga Propeller fusion (ECS).	davidsaunders 2011-04-24 08:43	11	3K	davidsaunders 2011-05-08 18:52
Lantronix Xport Pro - Propeller Tool UpLoads ?	Greg P 2011-05-05 09:01	6	2.1K	stef 2011-05-08 13:37

Propeller 1

Discussion List