before I start fiddling around a question:
Can I use my DIY-Propeller-Chip-boards with BlocklyProp?
I only did a quick crossreading about BlocklyProp.
As it is a graphical language. It has a lot of pre-configured commands like motor-control- LED-control etc. which are preconfigured to certain portpins etc.. Do I have a chance to use some more generalised commands like "create PWM" or "create a RC-Servo-Signal", or "receive characters through an UART" on my DIY-Propeller-Boards or will this end up in a lot off errors the compiler is reporting?