Great boards! Great Prices! Both you and Parallax are aggressively pricing boards, providing good value to end-users.
Looks like Prop pin P1 of Connector 1 in both schematics should be labeled P2 instead of P20 (otherwise, there's no P2).
Also, for the extended board/schematic, is Prop pin P20 (not P2) going to both connectors (CN1-17 & CN2-20) by design?
Maybe you can add links for these schematics to Propellerpowered when finailized (if you haven't already).
Thanks for designing these boards and making them available. --Jim
Thank you Jim.
Yes, you're right! Its a typo-error. I'll update my schematics & re-post again.
As for having both side with a similar pin (P20), yes. My initial idea was to have the left side (CN1) connecting input devices & the right side (CN2) the output/devices to be controlled. That way, the breadboard would look somewhat cleaner without wires going over this board. Both side too have 3v3v Vout & Gnd for you to connect to the breadboard's power-rail.
Comments
Thank you Jim.
Yes, you're right! Its a typo-error. I'll update my schematics & re-post again.
As for having both side with a similar pin (P20), yes. My initial idea was to have the left side (CN1) connecting input devices & the right side (CN2) the output/devices to be controlled. That way, the breadboard would look somewhat cleaner without wires going over this board. Both side too have 3v3v Vout & Gnd for you to connect to the breadboard's power-rail.
I've updated the 1st thread with schematics, pin labels & projects.
Thank you.