Did have a problem that confounded me for a while...
In the past, I've supplied power using Prop pins.
But, for this I was using Vdd and Gnd.
What I've learned is that FlashPoint will remain in SQI mode when the Prop is reset or reprogrammed.
It only reverts to SPI mode on command or power cycle...
That will cause my current driver to fail because it starts talking in SPI mode...
I'll have to update all the driver to attempt SQI mode first...
Comments
It was a bit of a chore to solder them by hand...
I sure hope they work!
Did have a problem that confounded me for a while...
In the past, I've supplied power using Prop pins.
But, for this I was using Vdd and Gnd.
What I've learned is that FlashPoint will remain in SQI mode when the Prop is reset or reprogrammed.
It only reverts to SPI mode on command or power cycle...
That will cause my current driver to fail because it starts talking in SPI mode...
I'll have to update all the driver to attempt SQI mode first...