Anyone else put 12v into a prop pin? - Page 2 — Parallax Forums

Anyone else put 12v into a prop pin?

turbosupra · 2010-07-11 18:30:46

I forgot to set up a resistor ladder and put 12v directly into my prop pin # 10. I can't connect to it now and both voltage regulators are getting very very hot when I supply the first one with 12v? I'm a little unsure as to how the two are connected? Anyone else experience this? Is just the chip needing replaced or should…

Comments

turbosupra Posts: 1,088

2010-07-15 02:54 edited 2010-07-15 02:54

Update

Tested the capacitors and they were fine, new chip and 5v/3.3v regulators and it runs code properly again [noparse]:)[/noparse]

or Register to comment.