Testing Attachments and Inserts
Whit
Posts: 4,191
This is a test.
Propeller Spin
PBASIC
E-mail link
test@test.com
And picture inserted...
Propeller Spin
'' File: PushbuttonLedTest.spin
'' Test program for the Propeller Education Lab "PE Platform Setup"
CON
_clkmode = xtal1 + pll16x ' Feedback and PLL multiplier
_xinfreq = 5_000_000 ' External oscillator = 5 MHz
LEDs_START = 0 ' Start of I/O pin group for on/off signals
LEDs_END = 15 ' End of I/O pin group for on/off signals
PUSHBUTTON = 18 ' Pushbutton Input Pin
PUB ButtonBlinkSpeed ' Main method
'' Sends on/off (3.3 V / 0 V) signals at approximately 2 Hz.
dira[LEDs_START..LEDs_END]~~ ' Set entire pin group to output
repeat ' Endless loop
! outa[LEDs_START..LEDs_END] ' Change the state of pin group
if ina[PUSHBUTTON] == 1 ' If pushbutton pressed
waitcnt(clkfreq / 4 + cnt) ' Wait 1/4 second -> 2 Hz
else ' If pushbutton not pressed
waitcnt(clkfreq / 20 + cnt) ' Wait 1/20 second -> 10 Hz
PBASIC
' What's a Microcontroller - FirstProgram.bs2
' BASIC Stamp sends a message to Debug Terminal.
' {$STAMP BS2}
' {$PBASIC 2.5}
DEBUG "Hello, it's me, your BASIC Stamp!"
END
E-mail link
test@test.com
And picture inserted...
Comments