Prop power output

Comments

• Phil Pilgrim (PhiPi) Posts: 23,514

  2009-09-09 02:28 edited 2009-09-09 02:28

  Check the "Key Thread Index" in the stickies at the top of this forum. There you will find a link to info about interfacing 5V devices.
  
  -Phil
• Leon Posts: 7,620

  2009-09-09 04:18 edited 2009-09-09 04:18

  A 3.3V device can be connected directly to the Propeller without any problems. The latter runs on 3.3V.
  
  Leon
  
  ▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
  Amateur radio callsign: G1HSM
  Suzuki SV1000S motorcycle
• W9GFO Posts: 4,010

  2009-09-09 04:18 edited 2009-09-09 04:18

  The Propeller chip requires 3.3v.
  
  The Demo Board, Proto Board and most development boards for the Propeller chip have both 3.3v and 5.0v regulators on them.
  
  Rich H
  
  ▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
  The Servo Boss, a 12 channel servo tester kit from Gadget Gangster.
• Phil Pilgrim (PhiPi) Posts: 23,514

  2009-09-09 06:24 edited 2009-09-09 06:24

  Well, between my parsing of the question (which, upon rereading, is most likely wrong) and every one else's, I think we've go it covered.
  
  -Phil