Shop OBEX P1 Docs P2 Docs Learn Events
Prop power output — Parallax Forums

Prop power output

copacetic353copacetic353 Posts: 52
edited 2009-09-09 06:24 in Propeller 1
Hello all,

So I know I've said it before, electronics is not my fort

Comments

  • Phil Pilgrim (PhiPi)Phil Pilgrim (PhiPi) Posts: 23,514
    edited 2009-09-09 02:28
    Check the "Key Thread Index" in the stickies at the top of this forum. There you will find a link to info about interfacing 5V devices.

    -Phil
  • LeonLeon Posts: 7,620
    edited 2009-09-09 04:18
    A 3.3V device can be connected directly to the Propeller without any problems. The latter runs on 3.3V.

    Leon

    ▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
    Amateur radio callsign: G1HSM
    Suzuki SV1000S motorcycle
  • W9GFOW9GFO Posts: 4,010
    edited 2009-09-09 04:18
    The Propeller chip requires 3.3v.

    The Demo Board, Proto Board and most development boards for the Propeller chip have both 3.3v and 5.0v regulators on them.

    Rich H

    ▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
    The Servo Boss, a 12 channel servo tester kit from Gadget Gangster.
  • Phil Pilgrim (PhiPi)Phil Pilgrim (PhiPi) Posts: 23,514
    edited 2009-09-09 06:24
    Well, between my parsing of the question (which, upon rereading, is most likely wrong) and every one else's, I think we've go it covered. smile.gif

    -Phil
Sign In or Register to comment.