Universal motor driver need input
Iguanaman
Posts: 35
Hello. I have the new Universal motor driver 64010 Rev B. I have looked over the UniversalMotorDriver P2 add on guide-V.1.1. I am trying to get it running. I have used the HB-25 motor control and I love it. But as soon as I find something I like it is no longer available. I wright simple code for the HB-25 and it works like fantastic. Is the Universal motor driver 64010 Rev B anything like the HB-25???? Where do I input the PWM to what pin??? There are 15 input pins with no pins. Could someone take me by the hand and show me where the pins are to input the PWM (plus with modulation). I have already found the ground pin. Can I use the same code that I use to run the HB-25 on the Propeller 1 (one)?? Is there a demonstration video some where out there??? Or some other paper work that I do not know about?? Thank you very much for any help in this matter. 18nov2025(tue)
Comments
Have you seen the product page?
https://www.parallax.com/package/universal-motor-driver-p2-add-on-board-documentation/
This unit is nothing like the HB-25. It can drive BLDC type motors as well as standard motors.
I assume you have the original Motor Mount and Wheel Kit.
Someone should have built code to run those motors.
Mike
Hello and thank you for your input. Mr. Rayman I have the documentation that you listed and I have been trying to make heads and tales of it but the going is slow. Mr. iseries your input tells me that I must try a different direction. It took me 3 months to get the HB-25 going and this may take longer. I thank both of you for your time. 20nov 2025(thur)