Propeller 2 Eval rev B set available

Comments

• Publison Posts: 12,366

  2020-09-25 17:11

  Dave, are you leaving us?
  
• DaveJenson Posts: 372

  2020-09-25 17:25

  No, just paring down on equipment...
  I'm actually looking forward to the P2Edge or P2D2 sets.
  
• Publison Posts: 12,366

  2020-09-25 17:31

  Sounds like a plan! I must do the same
• Maciek Posts: 668

  2020-09-25 19:39

  Funny, looks like I am on the reverse course. Just short on the money .
• cgracey Posts: 14,133

  2020-09-26 21:37

  DaveJenson wrote: »

  Prop 2 EVAL Rev C
  HyperRam \ HyperFlash
  Eval Protoboard (x2)
  Eval board accessory Set
  P2Eval Acrylic Enclosure
  
  Around $350 Original cost.
  
  I will consider all offers.

  
  We need to pull the tops off of those SMT header receptacles during manufacturing. They are only there to facilitate pick-and-place.
• Yanomani Posts: 1,524

  2020-09-27 00:00

  cgracey wrote: »

  We need to pull the tops off of those SMT header receptacles during manufacturing. They are only there to facilitate pick-and-place.

  
  They can be seen as some kind of a "virginity certificate"; like to open my own bottle of wine, despite I had no opportunity of doing so, at least by the past two years...
  
• Electrodude Posts: 1,621

  2020-09-27 04:17

  They also provide a small amount of protection from shorts caused by stray wires.
• VonSzarvas Posts: 3,278

  2020-09-27 05:59

  @DaveJenson
  Curiously looking at the pick tops mentioned, I noticed your board photo shows Rev B, whereas this forum thread title mentions Rev C.
• DaveJenson Posts: 372

  2020-09-28 14:33

  VonSzarvas wrote: »

  @DaveJenson
  Curiously looking at the pick tops mentioned, I noticed your board photo shows Rev B, whereas this forum thread title mentions Rev C.

  
  Corrected in original post.