spin2gui and flexgui rev b board

Comments

• ersmith Posts: 5,914

  2019-11-16 23:31

  Flexgui version 4.0.3 (the latest one) works with the Rev B board.
  
  spin2gui is obsolete, and will not work with Rev B. Use flexgui instead.
  
• pilot0315 Posts: 834

  2019-11-17 01:19

  Flexgui did not work either. I will try again. Thanks
• dgately Posts: 1,621

  2019-11-17 01:48

  pilot0315 wrote: »

  Flexgui did not work either. I will try again. Thanks

  
  If you expect help, you need to state more than "did no work"... What is your configuration (versions of tools, operating system, location in your file system where flexgui is located, etc...)? What was the specific problem that you saw?
  
  Other forum posters are using flexgui on their RevB boards with success, so it's quite possible that your configuration is unique.
  
  dgately
  
  
• JRoark Posts: 1,215

  2019-11-17 01:49

  This is odd. I’m using FlexGUI under Win10 with a P2 rev B and its fine. What OS are you running? (And a silly question... not trying to be a jerk here... are you plugged-in to the USB port labeled “PC” and not the aux power USB?)
• JRoark Posts: 1,215

  2019-11-17 02:31

  You might do a sanity check with a known operational (with FlexGUI) configuration. This is what works for me:
  
  1). All four DIP switches are pushed towards the text side of the DIP switch (ie, toward text "BOD", "Flash", "P59", "P60")
  2). Jumper "LDO VIn 5V" installed
  3). Jumper "Acc Hdr 5V" removed
  4). Jumper "Vdd 1V8" installed
  5). MicroSD card removed
  6). PC's USB cable connected to "PC USB" connnector on the board
  7). Green LED near "PC USB" connector is illuminated.
• pilot0315 Posts: 834

  2019-11-17 17:59

  Thanks to @Publison and @ersmith to alert me of the latest Pnut and Flexgui all is good.
  Both boards operational and I can get back to my projects.
  Did not know of the latest gui revisions.