Propeller QuickStart Board

Comments

• Dave Hein Posts: 6,347

  2014-09-29 15:32 edited 2014-09-29 15:32

  I measure 2.75"x1.75" on my QuickStart.
• Duane Degn Posts: 10,588

  2014-09-29 15:38 edited 2014-09-29 15:38

  It looks like the dimension are in thousandths of an inch. The look correct to me in this pdf.
• Genetix Posts: 1,771

  2014-09-30 09:50 edited 2014-09-30 09:50

  Thanks guys. I didn't even notice the board layout was dimensioned. The Product Guide says 3.5 x 1.0.
  http://www.parallax.com/downloads/p8x32a-quickstart-board-product-guide
• Duane Degn Posts: 10,588

  2014-09-30 09:57 edited 2014-09-30 09:57

  Genetix wrote: »

  Thanks guys. I didn't even notice the board layout was dimensioned. The Product Guide says 3.5 x 1.0.
  http://www.parallax.com/downloads/p8x32a-quickstart-board-product-guide

  
  You're right. Both the versions 1.0 and 1.1 have the error.
• Genetix Posts: 1,771

  2014-09-30 10:53 edited 2014-09-30 10:53

  Duane Degn wrote: »

  You're right. Both the versions 1.0 and 1.1 have the error.

  
  There are a number of errors in the documentation and I mentioned them a few months back.
• Courtney Jacobs Posts: 903

  2014-09-30 12:13 edited 2014-09-30 12:13

  This issue will be looked into.
  
  Thank you for pointing out the error.
• Courtney Jacobs Posts: 903

  2014-10-01 07:36 edited 2014-10-01 07:36

  The dimensions were corrected in a new version of the Product Guide.
  
  https://www.parallax.com/downloads/p8x32a-quickstart-board-product-guide