Propeller QuickStart Board

Genetix · 2014-09-29 15:29

What are the mounting hole dimensions because the documentation numbers are bigger than the overall board size which is physically impossible?

Dave Hein · 2014-09-29 15:32

I measure 2.75"x1.75" on my QuickStart.

Duane Degn · 2014-09-29 15:38

It looks like the dimension are in thousandths of an inch. The look correct to me in this pdf.

Genetix · 2014-09-30 09:50

Thanks guys. I didn't even notice the board layout was dimensioned. The Product Guide says 3.5 x 1.0.
http://www.parallax.com/downloads/p8x32a-quickstart-board-product-guide

Duane Degn · 2014-09-30 09:57

Genetix wrote: »

Thanks guys. I didn't even notice the board layout was dimensioned. The Product Guide says 3.5 x 1.0.
http://www.parallax.com/downloads/p8x32a-quickstart-board-product-guide

You're right. Both the versions 1.0 and 1.1 have the error.

Genetix · 2014-09-30 10:53

Duane Degn wrote: »

You're right. Both the versions 1.0 and 1.1 have the error.

There are a number of errors in the documentation and I mentioned them a few months back.

Courtney Jacobs · 2014-09-30 12:13

This issue will be looked into.

Thank you for pointing out the error.

Courtney Jacobs · 2014-10-01 07:36

The dimensions were corrected in a new version of the Product Guide.

https://www.parallax.com/downloads/p8x32a-quickstart-board-product-guide

Propeller QuickStart Board

Comments