Propeller and TeLit_865 Cellular Project Start-up, Need advise.
John Michael
Posts: 37
I have started this Program to send AT commands to a TeLit 865cf Cellular module via the Propeller for SMS messaging. This is Just the starting point to verify that the TeLit_865cf module is receiving the commands from the Propeller, learning as I proceed with this project so please be patient :>) I am using a PDB and ViewPort to monitor transmission and just learning these as well. I need help to make sure that I am using Extended_Full_Duplex_Serial correctly and have made comments on the lines that I need Help with. Any advise would be Greatly appreciated and I hope this helps other's delving into Cellular as well.
CON
_clkmode = xtal1 + pll16x ' Feedback and PLL multiplier
_xinfreq = 5_000_000 ' External oscillator = 5 MHz
wait = 5_000_000
VAR
long stack[30]
OBJ
serial : "Extended_Full_Duplex_Serial"
PUB MAIN
serial.Stop
serial.RxFlush
serial.start(31,30,0,115,200)
serial.str(String("AT+CMGF=1")) 'I will comment these commands once I make sure I'm using the Object correctly.
wait
serial.str(String("AT+CPMS="ME""))
wait
serial.str(String("AT+CNMI=1,1,0,0,0"))
wait
serial.str(String("AT+CMGS"+???????????"")) 'Phone number to send Message to.
wait
serial.dec(26) 'I need to send CTL+Z in this line.
wait
serial.dec(?) 'I need to send ENTER in this line.
wait
serial.str(String("Testing Equipment") 'Text Message to Send to Cellular Device.
wait
serial.dec(?) 'I need to send ENTER in this line to send the message.
serial.Stop 'Stop the Cog that the call to Extended_Full_Duplex_Serial started.
Comments
Moved my finger off the Enter key while looking at the ASCII chart :-)
Will Post the up-dated code later tonight.
http://forums.parallax.com/showthread.php?119128-PropPhone-update-SMS-and-Email-functionality-demo&highlight=propphone
John.