Memorystick + BS2 + 'dataloggerDemo.bs2' = 'Synchronizing...' + HANG

Bronson

Hi guys,

I just tried my new Memorystick Datalogger attached with BS2, I load the sample code (DataloggerDemoV1.0.bs2).
What happened is: My DEBUG TERMINAL showed 'Synchronizing...' and stop. There is no further response from my BS2.
If I study the code, it seems that when the BS2 sends 'E' command, there is no response from Memorystick. I have tried 2 different USB Disks. Still no luck...
I have also tried 'DataloggerTestV1.0.bs2', but same result.

Pls help me on this.

Regards,
Bronson

Mike Green

If you're not getting the response from the datalogger (for the "E" command), then the connection between the Stamp and the datalogger isn't working. Check your wiring, check the position of the jumper on the datalogger (for UART vs SPI mode), check that there's power going to the datalogger, etc.