HB-25 Motor Controller
Grettings to all,
Has anybody had problems useing the HB-25 for motor control in mode 1 simulating left and right servo's.
The problem I am having is that the HB-25 both left and right rotates without stoping ?
I do need to check the input control to the HB-25 witch I have not done yet.
I also need to check the timeing for the HB-25 requirments again.
I may be thinking about this to hard ?
Just throwing this one out there to see if other people have had problems too ?
I am useing the Bs2 and the board of education Rev.c
· Rob7
Post Edited (Rob7) : 10/11/2007 3:40:51 AM GMT
Has anybody had problems useing the HB-25 for motor control in mode 1 simulating left and right servo's.
The problem I am having is that the HB-25 both left and right rotates without stoping ?
I do need to check the input control to the HB-25 witch I have not done yet.
I also need to check the timeing for the HB-25 requirments again.
I may be thinking about this to hard ?
Just throwing this one out there to see if other people have had problems too ?
I am useing the Bs2 and the board of education Rev.c
· Rob7
Post Edited (Rob7) : 10/11/2007 3:40:51 AM GMT
Comments
I've also had that proplem , It turned out that my main battery voltage was to low.
▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Thank's Brian
www.truckwiz.com
·"Imagination is more important than knowledge..." ·· Albert Einstein
http://www.diycalculator.com/subroutines.shtml· My favorite website ( Bet you can't guess why)