New HYDRA Case!
![AndreL](https://forums.parallax.com/uploads/userpics/141/n2HIHMVK7J31M.jpg)
A HYDRA enthusiast build this case for it:
http://www.thedigitalmug.com/hydra_case/
He is going to sell them if you're interested. We will probably sell them on the XGS site as well once they are done. But, laser cut and I think hand assembled with epoxy. Pretty cool though.
Andre'
http://www.thedigitalmug.com/hydra_case/
He is going to sell them if you're interested. We will probably sell them on the XGS site as well once they are done. But, laser cut and I think hand assembled with epoxy. Pretty cool though.
Andre'
Comments
This way coin and wires won't find their way on your board. *lol*
--Andrew Arsenault.
I like the Cartridge case too...
Something for the Xmas wish list perhaps...
▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Living on the planet Earth might be expensive but it includes a free trip around the sun every year...
Experience level:
[noparse][[/noparse] ] Let's connect the motor to pin 1, it's a 6V motor so it should be fine.
[noparse][[/noparse] ] OK, I got my resistors hooked up with the LEDs.
[noparse][[/noparse]X] I got the Motor hooked up with the H-bridge and the 555 is supplying the PWM.
[noparse][[/noparse] ] Now, if I can only program the BOE-BOT to interface with he Flux Capacitor.
[noparse][[/noparse] ] I dream in SX28 assembler...
/Bamse
Oldbitcollector
▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Buttons . . . check. Dials . . . check. Switches . . . check. Little colored lights . . . check.
— Calvin, of 'Calvin and Hobbes.