I have got another usb converter which is not a prallax one. I mite have to purchase a prallax one because I have set the Latency to (1) but I still get the same
message IDE 0022.
Just got my prallax usb converter , but still going through the Error IDE-0022 (timeout) problem. I have also tried to set the Latency to 1 as well but no luck.
4x AA batteries does not give you 6V. 1,2V in loadx4 means 4,8V. And then the Servo controller will be unstable. As well when you are using 6V batteries and the batteries are half charged, the voltage might result in unstable voltage for the Javelin Stamp.
In my case, the voltage from a RC-car might be as low as 5,2V, something that results with restart of my controller. And then I'm using 7,2V RC battery pack.
My hint is to use 9V battery for the javelin controller and a seperate battery pack for the PWM motors.
(The jumper between Vin and Vm might work well untill the battery for the motors runs empty.
Comments
message IDE 0022.
THANKS
Hoping for some help.
In my case, the voltage from a RC-car might be as low as 5,2V, something that results with restart of my controller. And then I'm using 7,2V RC battery pack.
My hint is to use 9V battery for the javelin controller and a seperate battery pack for the PWM motors.
(The jumper between Vin and Vm might work well untill the battery for the motors runs empty.