Shop OBEX P1 Docs P2 Docs Learn Events
Javelin Stamp Demo Board Problem — Parallax Forums

Javelin Stamp Demo Board Problem

cybermimilcybermimil Posts: 10
edited 2007-05-30 07:20 in General Discussion
Hi,

I've recently buy a Javelin Stamp Demo Board.

I don't have the schema of this board to verify but I think I've a problem with a connection.

Can Someone confirm my opinion.

The link is a photo of tne back of the demo board. It's the P0 to P15 Javelin Header and I think it's not normally that the P4 and the P5 are linked....

Can I cut the link?
DSCN4017.JPG
640 x 480 - 67K

Comments

  • Chris SavageChris Savage Parallax Engineering Posts: 14,406
    edited 2007-05-29 17:00
    Hello,

    The bridge on those joints should not be there. I would carefully cut between the two pins with a set of diagonal cutters. If you continue to have problems please contact me directly in Tech Support. Take care.

    ▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
    Chris Savage
    Parallax Tech Support
  • cybermimilcybermimil Posts: 10
    edited 2007-05-29 17:16
    OK, I did this and I didn't destroy anything but I hope this error didn't dommage my javelin Stamp becaus I tried to work with before...
  • Chris SavageChris Savage Parallax Engineering Posts: 14,406
    edited 2007-05-29 19:02
    Is the Javelin programming now? Was it programming before?

    ▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
    Chris Savage
    Parallax Tech Support
  • cybermimilcybermimil Posts: 10
    edited 2007-05-30 06:01
    Yes I think it works.

    I try to program a Playstation2 Controller before and it didn't work.
  • Peter VerkaikPeter Verkaik Posts: 3,956
    edited 2007-05-30 07:20
    Here is the board schematic.

    regards peter
    pdf
    pdf
    JavelinBoardSchem.pdf
    891K
Sign In or Register to comment.