serial comms

damion

Hello,

I would like to hook up two stamps so that I can send data between them. Is there any paricular hardware set up for this or can I just hook them up directly?

Thanks,
Damion

damion

Actually I was thinking of setting them up with a two wire interface. I am a little confused as to how I will actually send the data as far as code goes. Do I have to shift the data out of the first stamp and then shiftin to the second? Sorry I'm just getting into how these interfaces work till now I've just been using bits of code that have already been written.

Mike Green

The Stamp manual has some examples of this in the section on SERIN/SEROUT and there's a Nuts and Volts article specifically on networking Stamps together (#s 55 and 56).

damion

thanks