stepper, DC, and servo motor control

daidalos62

Hello everyone....

I've done a quick search and havn't quite found the specific information that I'm looking for.

I'm quite new to the Basic Stamp and was hoping that I could get some info on controlling steppers, DC, and servo motors.
I know steppers and possibly servo's will require the use of motor controllers, one of which I have (ULN2003 for unipolar steppers).

So overall, if anyone could point me in the direction of a tutorial(s), and possibly what the code might look like or any info at all, I'd appreciate it!!

Warrlok

if u have a boe· u can run·4 servos right off the board
and most if not all the items have sample code http://www.parallax.com/html_pages/products/motorcontrol/motor_control.asp

and theres some whole programs in here http://www.parallax.com/html_pages/downloads/index.asp
have fun

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Problems are the "roads" of life,
solutions are only "onramps" to the next problem



············································· "Brad Smith"
·

daidalos62

awesome ... thanks alot !