Shop OBEX P1 Docs P2 Docs Learn Events
4 to 6 inch diameter gear to match stepper #27964 — Parallax Forums

4 to 6 inch diameter gear to match stepper #27964

verobelverobel Posts: 81
edited 2007-02-28 07:27 in General Discussion
Fellow stampers..
Do you know where I could find gear(s) to match the 27964··stepper motor sold at parallax. I am looking for 4 to 6 inches in diameter. Material could be nylon or brass.
Thanks, John

Comments

  • kelvin jameskelvin james Posts: 531
    edited 2007-02-28 07:27
    I don't think that motor would have enough torque to push something that big reliably. You probably won't find a gear that big with only a 3mm shaft bore size, most likely 1/4 to 3/8 in. Have a look through this site, it will give you a good idea on what is available. Plastic / delrin are the best bet.

    www.sdp-si.com/
Sign In or Register to comment.