Shop OBEX P1 Docs P2 Docs Learn Events
Showing Error — Parallax Forums

Showing Error

HONEYHONEY Posts: 1
edited 2007-01-30 02:54 in Robotics
idea.gif·I have a hexcrawler with me.....as I connect it to the PC and give RUN command to the programme......an ERROR window pops up......showing the message that " BASIC STAMP was not found "..........
···························· Please help me in dealing with this problem............THANKS

Comments

  • FranklinFranklin Posts: 4,747
    edited 2007-01-27 17:59
    Do you have the crawler powered up?

    ▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
    - Stephen
  • dandreaedandreae Posts: 1,375
    edited 2007-01-29 15:54
    Are you getting voltage to the board?· Do you have a voltmeter?· If so, what are you measuring on Vin to Vss on the Board of Education?


    Dave

    ▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
    Dave Andreae

    Parallax Tech Support·
  • bgthreebgthree Posts: 14
    edited 2007-01-30 02:54
    Also check that the chip is firmly pushed into the BOE. My BS2 popped out slightly and I got that error message until I pushed it back in.
Sign In or Register to comment.