Simulate the opening of a NC switch.
Vitor
Posts: 13
I'm building a simulator to test electronic components I rebuild.
Currently I test them by installing them on my cars and taking them for a spin.
When you step on the brakes, a NC switch opens and cuts the path of a square wave signal (71 Hz, 10.6V p-p), this signals the ABS unit to be ready.
Other than using a relay signaled by the stamp, any ideas how to cut the signal?
Thank you.
Currently I test them by installing them on my cars and taking them for a spin.
When you step on the brakes, a NC switch opens and cuts the path of a square wave signal (71 Hz, 10.6V p-p), this signals the ABS unit to be ready.
Other than using a relay signaled by the stamp, any ideas how to cut the signal?
Thank you.