Shop OBEX P1 Docs P2 Docs Learn Events
how does one setup interlacing in the TV driver? — Parallax Forums

how does one setup interlacing in the TV driver?

CJCJ Posts: 470
edited 2006-12-13 20:40 in Propeller 1
I am trying to get my propeller video output to work with an IPTV and it doesn't seem to like the video produced by the graphics demo. I would like to run it in interlaced mode to get it closer to a typical video signal(higher res signal, interlaced) how would I go about that?

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Who says you have to have knowledge to use it?

I've killed a fly with my bare mind.

Comments

  • Mike GreenMike Green Posts: 23,101
    edited 2006-12-13 20:37
    There is a set of parameters passed to TV.spin by whatever program uses it.· These are described in detail in comments near the end of TV.spin and include one parameter that enables/disables interlacing.· Have a look there.
    ·
  • CJCJ Posts: 470
    edited 2006-12-13 20:40
    thanks, I'll take a look there

    ▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
    Who says you have to have knowledge to use it?

    I've killed a fly with my bare mind.
Sign In or Register to comment.