trying to control power to turn it on and off with the stamp module
CC
Posts: 1
I am trying to control power to turn it on and off with the stamp module. But i need to figure out how to hook up 120 volts to my stamp module board and what circuits I should use.
Anybody give me some ideas of where to start.
Also I was looking for wireless newworking such as 802.11a,b,c,g does not matter the band. I just want a product that I can optain an ipaddress. Any ideas here?
Thanks
Chris
Post Edited By Moderator (Chris Savage (Parallax)) : 11/21/2006 4:23:09 PM GMT
Anybody give me some ideas of where to start.
Also I was looking for wireless newworking such as 802.11a,b,c,g does not matter the band. I just want a product that I can optain an ipaddress. Any ideas here?
Thanks
Chris
Post Edited By Moderator (Chris Savage (Parallax)) : 11/21/2006 4:23:09 PM GMT
Comments
This is a relay board that is very simple to use with the basic stamp.
http://cgi.ebay.com/4-CH-TTL-Driv-Relay-PCB-for-Xmas-decor-Basic-Stamp-PIC_W0QQitemZ180051069724QQihZ008QQcategoryZ78205QQssPageNameZWDVWQQrdZ1QQcmdZViewItem
As the ad says perfect for, “driving heavy inductive loads such as AC motors, magnetic lock etc.” Relays contact spec - 250V, 10Amp (Not bad for around $10) TTL logic control input is perfect for the basic stamp and very easy to use.
·· Please see the following recent thread which also covered this subject.· Take care.
http://forums.parallax.com/showthread.php?p=616250
▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Chris Savage
Parallax Tech Support