Using the Parallax 433 MHz RF Receiver with the Propeller.

lmoliver

I want to use the Parallax 433 MHz RF Receiver (#27981) with the Propeller Demo Board.
Somebody has suggested to me to use some standard serial object for communications, but I do not find examples written in Spin.

Also I have tried to emulate then SERIN BS2 command using the “BS2 Functions” object but I’m not able to optimize that code to use only SERIN command (still I do not “dance” well with the SPIN).

Somebody has written something in SPIN to receive data with the RF Receiver?

Thanks

Martin Hebel

To use the 433 with the propeller, you should be able to use either the SEROUT/SERIN methods in BS2_Functions or use the FullDuplexSerial library, simply assign the right pins for TX/RX.

-Martin

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Martin Hebel
StampPlot - Graphical Data Acquisition and Control
AppBee -·2.4GHz Wireless Adapters & transceivers·for the BASIC Stamp & Other controllers·

Newzed

The 433 operates of 5VDC so you need to do something to the output before you feed it to the Prop.

Sid

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Sid Weaver
Don't have VGA?

Newzed@aol.com
·

Martin Hebel

I apologize for the imcomplete answer on this, will you be transmitting data from the propeller, or receiving it, or both?
-Martin

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Martin Hebel
StampPlot - Graphical Data Acquisition and Control
AppBee -·2.4GHz Wireless Adapters & transceivers·for the BASIC Stamp & Other controllers·

lmoliver

Ok, I will try to use again the SEROUT/SERIN methods in BS2_Functions; I will be only receiving data from the propeller.

Thanks