Shop OBEX P1 Docs P2 Docs Learn Events
Where can I find the socket used on the Prop Board — Parallax Forums

Where can I find the socket used on the Prop Board

Paul K.Paul K. Posts: 150
edited 2006-10-04 14:45 in General Discussion
I have looked thru a couple of sites and no luck.· I'm looking for the sockets that allow you to remove the crystal on the Prop Board.· Or at least what they are called.

Thanks
Paul

Comments

  • Paul BakerPaul Baker Posts: 6,351
    edited 2006-10-04 00:58
    They are call "pin receptacles", and you'll want one that accepts .015-.022" pins (the oscillators used for the demo board have 0.018" pins, I measured them with a caliper to be sure). Something like the Mill-Max 0552 series should work and is very close to what was used for the board (0.14" length). Digikey sells them for $0.93 per 10, the manufacturer part number is 0552-1-15-15-11-27-10-0.

    ▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
    Paul Baker
    Propeller Applications Engineer

    Parallax, Inc.
  • Paul K.Paul K. Posts: 150
    edited 2006-10-04 01:13
    Thanks
  • Paul BakerPaul Baker Posts: 6,351
    edited 2006-10-04 02:32
    Paul, before you go ordering some, let me have someone check the BOM for the board, and I will verify I have the right part#.

    ▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
    Paul Baker
    Propeller Applications Engineer

    Parallax, Inc.
  • Paul K.Paul K. Posts: 150
    edited 2006-10-04 09:00
    That would be great.
    Thanks
  • Chris SavageChris Savage Parallax Engineering Posts: 14,406
    edited 2006-10-04 14:45
    Just to follow up on Paul’s post, the manufacturer part number he posted is correct.· These are MillMax 0.015/0.021” units.· Take care.

    ▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
    Chris Savage
    Parallax Tech Support
Sign In or Register to comment.