PRC (1.02), programming, and USB2SER
Brian Riley
Posts: 626
I had thought that Mark and I had made it quite clear in the various discussions, and on the web page that the hardware programming interface for the Propeller Robot Controller was the Parallax USB2SER device (parallax p/n 28024). But over the last few days I have had some email exchanges with people interested in the PRC that let me to believe it is not clear at all.
Now if you tap the 3v bus for power you could hand wire up either of the two simple transistor to RS232 interfaces that have been posted and use either of them as well.
There are now less than 30 boards left of the original lot.
www.wulfden.org/PRC/
▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
cheers ... brian riley, n1bq, underhill center, vermont
See the K107 Serial LCD Controller at
www.wulfden.org/k107/
Now if you tap the 3v bus for power you could hand wire up either of the two simple transistor to RS232 interfaces that have been posted and use either of them as well.
There are now less than 30 boards left of the original lot.
www.wulfden.org/PRC/
▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
cheers ... brian riley, n1bq, underhill center, vermont
See the K107 Serial LCD Controller at
www.wulfden.org/k107/