running a servo on a basic stamp without a POT
Hello all,
I was wondering if there is a way to run a servo on the basic stamp all by computer without the POT. I know in the manual there is an experiment with the POT, but I want total autonomous control. I know Parallax sells the servo controller, But I only need to control on servo. Can anyone herlp with this.
Part two,
Is there a way to run two programs together on the basic stamp? Like control my servo and run the motor mind B ?
Thanks in advance for you help
Justin
I was wondering if there is a way to run a servo on the basic stamp all by computer without the POT. I know in the manual there is an experiment with the POT, but I want total autonomous control. I know Parallax sells the servo controller, But I only need to control on servo. Can anyone herlp with this.
Part two,
Is there a way to run two programs together on the basic stamp? Like control my servo and run the motor mind B ?
Thanks in advance for you help
Justin
Comments
Dave
▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Dave Andreae
Tech Support
dandreae@parallax.com
Http://www.parallax.com
·
▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
- Stephen