Please Help with a Receiver and Transmitter

lisandro

Hi

Im trying to control a 4WD2 from linxmotion with a BS2, the rover its working, but i wanna use it via RF, I need some sample code for a receiver and transmitter.

Please someone can help with the code, or just some sample codes.

Thanks.

dandreae

Here are a couple of examples that may help you with your project (attached).

Dave



▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Dave Andreae

Tech Support
dandreae@parallax.com
Http://www.parallax.com

lisandro

thanks for the codes

Im using the wireless 418 MHz Module Tranceiver from Paralax, does that matter???
does any one can help me with a diagram/schematic to conected to the BS and the wiring

thanks

lisandro

or any other sample code with schematics

dandreae

The connection is a very simple one, first connect the RF module's 5v pin·to Vdd of the BASIC Stamp board.· Second, connect the ground pin of the RF module to Vss of the BASIC Stamp board. Third, connect the RX or TX to an I/O pin on the BASIC Stamp board and you are ready to go.· I have more sample codes if you need them.

Dave

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Dave Andreae

Tech Support
dandreae@parallax.com
Http://www.parallax.com

·