Shop OBEX P1 Docs P2 Docs Learn Events
Propeller "plug" — Parallax Forums

Propeller "plug"

HeadShotHeadShot Posts: 5
edited 2006-07-20 20:08 in Propeller 1
The Prop manual shows a schematic on page 17 with a Propeller Plug interface to the host. I can't find a reference at Parallax or here on the forums. What do we know about it?

Thanks, Dan

Comments

  • Mike GreenMike Green Posts: 23,101
    edited 2006-07-20 17:26
    The Propellor plug is a special version of the USB2SER adapter that has a mechanical lock. The demo board was finally built with an on-board USB-serial adapter, so neither were necessary. I think Chip mentioned that they were still planning on using the Propellor Plug design at some point, but there are no products that use it currently and the USB2SER adapter would have worked as a substitute.
  • HeadShotHeadShot Posts: 5
    edited 2006-07-20 20:08
    So the USR2SER could provide the Prop/Host connection, I assume for a breadboard setup. Thanks for the response. Dan
Sign In or Register to comment.