Shop OBEX P1 Docs P2 Docs Learn Events
Any way to send data from my PC to BS board via RF?? — Parallax Forums

Any way to send data from my PC to BS board via RF??

DemoncleanerDemoncleaner Posts: 17
edited 2006-06-03 00:16 in Robotics
Hi all,

I would like to know if there is a way to send data from my PC to my Basic Stamb board
via RF.
I found a Parallax product for receiver in this link http://www.parallax.com/detail.asp?product_id=27981
and for transmiter in this http://www.parallax.com/detail.asp?product_id=27980.
Which way could i connect the transmiter with the serial port? Do i need to use a board to do it???

P.S.:I need a transmiter - receiver, not 2 x tranceivers

thx

Comments

  • Chris SavageChris Savage Parallax Engineering Posts: 14,406
    edited 2006-05-29 17:35
    On the PC side you would need a MAX232 or similar driver to reduce the RS-232 levels down to TTL levels that the transmitter uses.· On the PC you would simply open a COM channel at the same parameters as the BASIC Stamp connected to the receiver is set up for.


    ▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
    Chris Savage
    Parallax Tech Support
    csavage@parallax.com
  • DemoncleanerDemoncleaner Posts: 17
    edited 2006-06-03 00:16
    thank you very much
Sign In or Register to comment.