Shop OBEX P1 Docs P2 Docs Learn Events
locating PO on PDB — Parallax Forums

locating PO on PDB

mkeith123mkeith123 Posts: 2
edited 2006-05-17 14:07 in BASIC Stamp
I am doing my first experiment on the proffesional development board. I must connect a wire from the PO on the BS2 to LED 0. I know that pin 5 on the BS2 is PO, but how do I tell which hole no. that corresponds to on the bread board?
The LED 0 is fairly obvious, but not the BS2 pins.

Comments

  • Chris SavageChris Savage Parallax Engineering Posts: 14,406
    edited 2006-05-17 03:37
    The I/O pins are already brought out to a header labeled P0-P15...Not the breadboard.· See the attachment...You will basically connect a wire between the two points indicated by the arrow.


    ▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
    Chris Savage
    Parallax Tech Support
    csavage@parallax.com


    Post Edited (Chris Savage (Parallax)) : 5/17/2006 2:15:11 PM GMT
    28138_a.JPG
    450 x 280 - 31K
  • Jon WilliamsJon Williams Posts: 6,491
    edited 2006-05-17 14:07
    You'll find the P0 connection on the right side of header X15 (near the reset button).

    ▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
    Jon Williams
    Applications Engineer, Parallax
Sign In or Register to comment.