Help with your SX48 Protoboard
Tony Leyland
Posts: 71
Hi,
I would like to share with the rest of the community what changes I've made to the standard SX48 Protoboard, to allow
components to be freely inserted - Please see the attached photograph to see what I mean.
The breadboard is available from Parallax. The headers I obtained from a supplier here in the UK.
What you end up with is a development board that is similar to the SX-Tech board that is available for the SX28. I found
that these changes are what I needed to migrate from the SX28 to SX48 code development. I realise that what I've show here
is fairly obvious to many, but just in case, I though I should share this to help any newcomers.
Cheers
Tony
I would like to share with the rest of the community what changes I've made to the standard SX48 Protoboard, to allow
components to be freely inserted - Please see the attached photograph to see what I mean.
The breadboard is available from Parallax. The headers I obtained from a supplier here in the UK.
What you end up with is a development board that is similar to the SX-Tech board that is available for the SX28. I found
that these changes are what I needed to migrate from the SX28 to SX48 code development. I realise that what I've show here
is fairly obvious to many, but just in case, I though I should share this to help any newcomers.
Cheers
Tony
1024 x 768 - 157K
Comments
James
tony