Shop OBEX P1 Docs P2 Docs Learn Events
Boe-Bot — Parallax Forums

Boe-Bot

hlwhlw Posts: 7
edited 2006-04-11 23:03 in Robotics
I'm working on the Boe-Bot and made it to page 181. It says that you can modify the IF...THEN statements to make the LED indicators light. When I add the code the Whiskers act like reset switches. I have tried comenting out the high low statements but nothing words.
harold

Comments

  • Chris SavageChris Savage Parallax Engineering Posts: 14,406
    edited 2006-04-09 20:13
    Recheck your wiring.· If you're still in doubt, remove everything from the breadboard and re-wire it.· Sometimes you miss the same problem over and over and the only way out is to startfresh.

    ▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
    Chris Savage
    Parallax Tech Support
    csavage@parallax.com
  • hlwhlw Posts: 7
    edited 2006-04-09 21:31
    Thanks Chris,

    I feel like an old fool, I left out the 220 ohm resistors. Well put another one down for operator head space.

    Thanks again.
  • hlwhlw Posts: 7
    edited 2006-04-09 22:16
    After putting the resistors in it still was acting up the same way and I thought I had burnt the stamp. But low batteries cause the same symtem.
    Thanks again
    I'll call myself Head_Space from now on [noparse]:)[/noparse]
  • Chris SavageChris Savage Parallax Engineering Posts: 14,406
    edited 2006-04-10 05:44
    So is it working now?

    ▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
    Chris Savage
    Parallax Tech Support
    csavage@parallax.com
  • hlwhlw Posts: 7
    edited 2006-04-11 23:03
    roll.gif·Yes, now that it's wired correctly and new batters Every thing is fine ( until the next Time )
    Thanks Again
Sign In or Register to comment.