Shop OBEX P1 Docs P2 Docs Learn Events
Serial Settings for the USB PSC Servo Controller? — Parallax Forums

Serial Settings for the USB PSC Servo Controller?

hackman127hackman127 Posts: 34
edited 2006-02-22 17:49 in BASIC Stamp
Hey guys, can anyone tell me what the correct terminal settings are for the USB PSC Servo Controller if I want to talk directly to it through a term program? I am not planning on using this board in conjunction with a BS2, I want to use it independantly.

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Luke

The perversity of nature is nowhere better demonstrated by the fact that, when
exposed to the same atmosphere, bread becomes hard while crackers become soft.

Comments

  • Chris SavageChris Savage Parallax Engineering Posts: 14,406
    edited 2006-02-22 15:55
    Luke,

    ·· As per our e-mail conversation the settings are 2400 bps, 8 data bits, no parity, 1 stop bit.


    ▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
    Chris Savage
    Parallax Tech Support
    csavage@parallax.com
  • hackman127hackman127 Posts: 34
    edited 2006-02-22 17:49
    Chris,

    I didn't see any confirmation of the term settings in the previous thread. Thank you for the info.

    BTW, I did find my problem. My term program was sending LF instead of CR.

    ▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
    Luke

    The perversity of nature is nowhere better demonstrated by the fact that, when
    exposed to the same atmosphere, bread becomes hard while crackers become soft.
Sign In or Register to comment.