Pin out data for a Yamaha BC3
Piper984
Posts: 74
Hello gang,
I have a need to develop a BS2 based interface to a Yamaha BC3 breath controller. It's a·variable resistance device that allows breath from a mouth piece to be translated into analog signal.· Some MIDI controllers have input jacks for it, and circuits for converting the analog into MIDI.· I'd like to implement an interface for this device·for a homespun MIDI controller I am developing, but cannot find any technical information on the BC3.· I have emailed Yamaha but no response yet.· Just hoping someone out here in Stamp land might have mucked about with one of these before.· Any data would be helpful.· I can't even get any R readings from·my multimeter.
·
I have a need to develop a BS2 based interface to a Yamaha BC3 breath controller. It's a·variable resistance device that allows breath from a mouth piece to be translated into analog signal.· Some MIDI controllers have input jacks for it, and circuits for converting the analog into MIDI.· I'd like to implement an interface for this device·for a homespun MIDI controller I am developing, but cannot find any technical information on the BC3.· I have emailed Yamaha but no response yet.· Just hoping someone out here in Stamp land might have mucked about with one of these before.· Any data would be helpful.· I can't even get any R readings from·my multimeter.
·
Comments
http://bigbriar.com/forum/viewtopic.php?t=632&sid=ca35a2090d64bd875e703390666eceb5
▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Chris Savage
Parallax Tech Support
csavage@parallax.com