Wiring Trans/Rev to Basic Stamps for Serin/Serout
I am attempting to wire a wireless Transmitter and Receiver to Two Stamps using Serin/Serout and I am confused about the wiring for each.
Could I wire directly from the SIOPIN ( Data Out), FCPIN (Grnd) to the transmitter and reciver or do I need some kind of a resistor network......
Thank You
Guido
Could I wire directly from the SIOPIN ( Data Out), FCPIN (Grnd) to the transmitter and reciver or do I need some kind of a resistor network......
Thank You
Guido
Comments
Correction, it is a 5V unit you may interface it directly with your stamp.
Post Edited (Paul Baker) : 5/10/2005 11:38:42 PM GMT
I does say 5 volt supply, don't want to gamble on looooosing a Stamp, So do you have any ideas?
I will give it a try and see what happens.....Will post if or when I get it going!
Thanks Again for your Help
Guido