Shop OBEX P1 Docs P2 Docs Learn Events
EMIC Problem — Parallax Forums

EMIC Problem

ArchiverArchiver Posts: 46,084
edited 2004-07-15 05:25 in General Discussion
EMIC was working perfectly, then all of a sudden I'm getting "No response
from EMIC' messages. Changed control lines, went from BS2 to BSE, all to no
avail.

Any suggestions?

Sid


[noparse][[/noparse]Non-text portions of this message have been removed]

Comments

  • ArchiverArchiver Posts: 46,084
    edited 2004-07-15 05:25
    If you are using the sample code that ships with the EMIC, try
    increasing the pauses for initialization. Also, I found that
    POWERING DOWN when I reset helps. The EMIC can be touchy, but after
    I increased the pauses for initialization, there were no problems.

    Ryan


    --- In basicstamps@yahoogroups.com, Newzed@a... wrote:
    > EMIC was working perfectly, then all of a sudden I'm getting "No
    response
    > from EMIC' messages. Changed control lines, went from BS2 to BSE,
    all to no
    > avail.
    >
    > Any suggestions?
    >
    > Sid
    >
    >
    > [noparse][[/noparse]Non-text portions of this message have been removed]
Sign In or Register to comment.