RC and PWM
Archiver
Posts: 46,084
In a message dated 5/3/2004 12:50:26 PM Eastern Daylight Time,
diepenpj@h... writes:
> i think i can put the pwm into a hbridge to control a motor, but my
> question is, how can i turn the motor in reverse by the RC control?
> (PWM goes from 1 to 2 ms if I am not mistaken...)
>
>
Run it thru a DPDT relay. motor to COM, fwd to NC, rev to NO. Flip the
connections from NC to NO.
Sid Weaver
I2C on a BS2 platform.................
http://www.visualmuses.com/chipcircuit/index.html
[noparse][[/noparse]Non-text portions of this message have been removed]
diepenpj@h... writes:
> i think i can put the pwm into a hbridge to control a motor, but my
> question is, how can i turn the motor in reverse by the RC control?
> (PWM goes from 1 to 2 ms if I am not mistaken...)
>
>
Run it thru a DPDT relay. motor to COM, fwd to NC, rev to NO. Flip the
connections from NC to NO.
Sid Weaver
I2C on a BS2 platform.................
http://www.visualmuses.com/chipcircuit/index.html
[noparse][[/noparse]Non-text portions of this message have been removed]
Comments
try to control a motor with RC. Have a receiver, in my opinion gives
a pwm output (can connect a servo to it, works fine)
i think i can put the pwm into a hbridge to control a motor, but my
question is, how can i turn the motor in reverse by the RC control?
(PWM goes from 1 to 2 ms if I am not mistaken...)
Pieter-Jan