Newbie with questions here!

Archiver

Hi,

New to the stamp, the forum and have a few questions.

My second PBASIC project was to interface a piezo gyro to the BS2 and, in
turn, read the corrected output of the gyro.
I sent out a pulsout command: PULSOUT, 15, 750 as a loop, then connected a
servo to the gyro to verify operation and it worked as expected. My next
step was to PULSIN the output of the gyro to read its corrected state in
debug in hopes of then setting limits to trigger a event later in the
program. All of my documentation on the PULSIN command is not very clear and
offers no examples. Can anyone help me out?

Thanks,
Eric

Archiver

There are examples in the manual and the help file.

-- Jon Williams
-- Applications Engineer, Parallax
-- Dallas Office

---

Original Message

---

From: Eric Rodemeyer [noparse]/noparse]mailto:[url=http://forums.parallaxinc.com/group/basicstamps/post?postID=FzHz2b440aUz3MEf1_YH67j2vqXLsJp_3O9Wg2uq1Pa1IENP68uERTtx4rZoZLM3_qEAyYvlErAMlOb3Vu6Nz30]siliconsurfer1@m...[/url
Sent: Wednesday, April 07, 2004 8:45 PM
To: basicstamps@yahoogroups.com
Subject: [noparse][[/noparse]basicstamps] Newbie with questions here!


Hi,

New to the stamp, the forum and have a few questions.

My second PBASIC project was to interface a piezo gyro to the BS2 and,
in turn, read the corrected output of the gyro. I sent out a pulsout
command: PULSOUT, 15, 750 as a loop, then connected a servo to the gyro
to verify operation and it worked as expected. My next step was to
PULSIN the output of the gyro to read its corrected state in debug in
hopes of then setting limits to trigger a event later in the program.
All of my documentation on the PULSIN command is not very clear and
offers no examples. Can anyone help me out?

Thanks,
Eric