Regarding O. T.
Archiver
Posts: 46,084
Hi guys, forgive my lack of protocol. My question about the latch
verses register, should have been put under the context of a stamp
accessing a chip with the features, i am just learning and some of
these terms are quite confusing, Can anyone suggest a further
information on reading a chips timing, register, and address ponter
incrementing. I have also written some code for the stamp that
outputs to a stepper driver and displays the position on a LCD, it
might answer alot of motion control questions i have seen over the
past few months, would it be worthwhile to post this in your files
section?
thanks, mark
verses register, should have been put under the context of a stamp
accessing a chip with the features, i am just learning and some of
these terms are quite confusing, Can anyone suggest a further
information on reading a chips timing, register, and address ponter
incrementing. I have also written some code for the stamp that
outputs to a stepper driver and displays the position on a LCD, it
might answer alot of motion control questions i have seen over the
past few months, would it be worthwhile to post this in your files
section?
thanks, mark