Circuit repeater?
Archiver
Posts: 46,084
Well i have a project going on and i was wondering if there were some
helpful minds here that could help me. Im using the stamp 1 for a
very basic operation.
Basically, I need to wire the stamp 1 between a microswitch and a
board, I need the stamp 1 to repeatedly close the circuit. Basically
pulling the trigger over and over. It will be powered by a 9 volt.
Very simple.
I have a board of education already lying around, as well as a
programming cable and softare. I just need to know where to connect
what and what source to put in...
helpful minds here that could help me. Im using the stamp 1 for a
very basic operation.
Basically, I need to wire the stamp 1 between a microswitch and a
board, I need the stamp 1 to repeatedly close the circuit. Basically
pulling the trigger over and over. It will be powered by a 9 volt.
Very simple.
I have a board of education already lying around, as well as a
programming cable and softare. I just need to know where to connect
what and what source to put in...