Memsic and BS2sx
Archiver
Posts: 46,084
Hello
I am currently trying to integrate a Memsic 2125 accelerometer into my project
but
am having certain difficulties...
a) The sample code that comes with the memsic does not follow through a 360
degree motion(arc). this is the main item. This would be just "dandy" if someone
outthere had the code implementation.
b) When trying the the "rotation" sample code I get the folowing prinited on the
debug
screen;
x -4.000g
y - 4.000g
Tilt : 32 Brads
240 degrees
No matter how I place the board the reading do not change.
The same thing happens with the "dual" sample code, the data captured from the
memsic is erratic.
when I puch he reset button on the carrier board, I get a flash of alternate
reading for
x, y ... and then nothing.
Any help would be appreciated. I also read on the usergroup here that parallax
were
going to update the memsic pdf to include the "360 degrees" code. Any news on
this?
thank
elio
I am currently trying to integrate a Memsic 2125 accelerometer into my project
but
am having certain difficulties...
a) The sample code that comes with the memsic does not follow through a 360
degree motion(arc). this is the main item. This would be just "dandy" if someone
outthere had the code implementation.
b) When trying the the "rotation" sample code I get the folowing prinited on the
debug
screen;
x -4.000g
y - 4.000g
Tilt : 32 Brads
240 degrees
No matter how I place the board the reading do not change.
The same thing happens with the "dual" sample code, the data captured from the
memsic is erratic.
when I puch he reset button on the carrier board, I get a flash of alternate
reading for
x, y ... and then nothing.
Any help would be appreciated. I also read on the usergroup here that parallax
were
going to update the memsic pdf to include the "360 degrees" code. Any news on
this?
thank
elio
Comments
used the published code and get a reliable reading from 0 to about 340 degrees
of rotation.
azeasi
[noparse][[/noparse]Non-text portions of this message have been removed]