simple RF link
Archiver
Posts: 46,084
I need a simple BS2 prgm to look at the outputs of my LINX receiver
it has 8 ouputs, connected to 8 I/O lines on the BS2. The LINX only
stays high while a button is pressed on the transmitter. The LINX has
debouce etc so the signal is clean. The BS2 I/O then has 3 ( pins)
lines to a 74HC595. I can do the serial/parallel part OK myslef but I
seem to be confused on how best to handle the 1 of 8 inputs.
Thanks for any help..
( Thanks for all your ideas about my recovery attempts, the bad news
is that it now gone and the good news is that the STAMP is OK )
it has 8 ouputs, connected to 8 I/O lines on the BS2. The LINX only
stays high while a button is pressed on the transmitter. The LINX has
debouce etc so the signal is clean. The BS2 I/O then has 3 ( pins)
lines to a 74HC595. I can do the serial/parallel part OK myslef but I
seem to be confused on how best to handle the 1 of 8 inputs.
Thanks for any help..
( Thanks for all your ideas about my recovery attempts, the bad news
is that it now gone and the good news is that the STAMP is OK )