Hello

Archiver

Hi. My name is Wayne Bays From North Bloomfield Ohio.
I am new to Basic Stamps. I have learned to make a few programs.
Simple stuff like Blinking LED's on and off. I Would Like to use my stamp to
run Two stepper motors. But I lack the Knowledge to even make a connection
between the motors, controller and stamp. If Someone Could give me some
Information on where to get started It would be truly appreciated.

I have a 2P40 Starter Kit. A Bistep A05 Motor Controller and Two 12 Volt
Stepper Motors.

Thanks
Wayne bays

Archiver

Look at StampWorks experiment # 26
http://www.parallax.com/html_pages/resources/sw/sw.asp

---

Original Message

---

From: <KAW1954@a...>
To: <basicstamps@yahoogroups.com>
Sent: Saturday, April 26, 2003 8:31 AM
Subject: [noparse][[/noparse]basicstamps] Hello "I am new to Basic Stamps"


> Hi. My name is Wayne Bays From North Bloomfield Ohio.
> I am new to Basic Stamps. I have learned to make a few programs.
> Simple stuff like Blinking LED's on and off. I Would Like to use my stamp
to
> run Two stepper motors. But I lack the Knowledge to even make a connection
> between the motors, controller and stamp. If Someone Could give me some
> Information on where to get started It would be truly appreciated.
>
> I have a 2P40 Starter Kit. A Bistep A05 Motor Controller and Two 12
Volt
> Stepper Motors.
>
> Thanks
> Wayne
bays
>
> To UNSUBSCRIBE, just send mail to:
> basicstamps-unsubscribe@yahoogroups.com
> from the same email address that you subscribed. Text in the Subject and
Body of the message will be ignored.
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>

Archiver

You might want to download our StampWorks documentation to help get you up to
speed on programming BASIC Stamps. It does include a stepper experiment
which does not require a controller. Once you get used to programming at the
hardware level, the rest will be easy.

-- Jon Williams
-- Parallax


In a message dated 4/26/2003 7:33:12 AM Central Standard Time,
KAW1954@a... writes:

> Hi. My name is Wayne Bays From North Bloomfield Ohio.
> I am new to Basic Stamps. I have learned to make a few programs.
> Simple stuff like Blinking LED's on and off. I Would Like to use my stamp
> to
> run Two stepper motors. But I lack the Knowledge to even make a connection
> between the motors, controller and stamp. If Someone Could give me some
> Information on where to get started It would be truly appreciated.
>
> I have a 2P40 Starter Kit. A Bistep A05 Motor Controller and Two 12 Volt
>
> Stepper Motors.
>



[noparse][[/noparse]Non-text portions of this message have been removed]