second trial!
Archiver
Posts: 46,084
Hi, everybody. I´m new in this group and forgive me for something that can go
wrong from me.
I bought my Basic Stamp some years ago and now I´m trying to make it work again.
However, when I try to run
a program, wrote on my PC, I receive the message: "ERROR EEPROM verify failed".
At the very begin I thought it could be an eeprom error (obvious!) but there´s
an old program (perhaps 2 years old) running in the Stamp, because I can see the
LEDs blinking on the protoboard.
When I disconnect the cable that link my PC to the basic stamp, I got the
message: HARDWARE NOT PRESENT (or something alike). So, it was there!
Could somebody help me, please? Thank you very much in advance.
zenito
[noparse][[/noparse]Non-text portions of this message have been removed]
wrong from me.
I bought my Basic Stamp some years ago and now I´m trying to make it work again.
However, when I try to run
a program, wrote on my PC, I receive the message: "ERROR EEPROM verify failed".
At the very begin I thought it could be an eeprom error (obvious!) but there´s
an old program (perhaps 2 years old) running in the Stamp, because I can see the
LEDs blinking on the protoboard.
When I disconnect the cable that link my PC to the basic stamp, I got the
message: HARDWARE NOT PRESENT (or something alike). So, it was there!
Could somebody help me, please? Thank you very much in advance.
zenito
[noparse][[/noparse]Non-text portions of this message have been removed]