talking to quadrovox from stamp

Archiver

hey guys,

if anyone has played with the qv430p from quadrovox, how should the
command be set up to talk to it from the stamp? I know it's the
serout command but i'm not sure what address to call up (say for the
first message or second) Also, does it matter what i set the baudmode
at? thanks in advance.

Jon

Archiver

At 05:29 PM 1/4/03 +0000, jhtoolman2000 <jhtoolman2000@y...> wrote:
>hey guys,
>
>if anyone has played with the qv430p from quadrovox, how should the
>command be set up to talk to it from the stamp? I know it's the
>serout command but i'm not sure what address to call up (say for the
>first message or second) Also, does it matter what i set the baudmode
>at? thanks in advance.
>
>Jon

Jon -

Here is a pretty good run down on what is required. There is also a link to
the datasheet: http://www.quadravox.com/qv430p.htm

I've never used one so I can't answer your questions directly. I hope the above
link is helpful.

Regards,

Bruce Bates

Archiver

You can get Stamp-specific code here:

<A
HREF="http://www.parallax.com/detail.asp?product_id=27967">http://www.parallax.c\
om/detail.asp?product_id=27967</A>

-- Jon Williams
-- Parallax


In a message dated 1/4/2003 11:30:33 AM Central Standard Time,
jhtoolman2000@y... writes:

> hey guys,
>
> if anyone has played with the qv430p from quadrovox, how should the
> command be set up to talk to it from the stamp? I know it's the
> serout command but i'm not sure what address to call up (say for the
> first message or second) Also, does it matter what i set the baudmode
> at? thanks in advance.
>
> Jon
>



[noparse][[/noparse]Non-text portions of this message have been removed]