RS 232 Communication
Archiver
Posts: 46,084
Hi all,
I am written a program to control the zooming of a Sony video camera
of the model: FCB EX 470LP through the dedicated serial input pin.
The program works.
However, when I expand my program to pass a variable called stepsize
when is dependent on the zooming position to another basic stamp,
when a switch is on, through the i/o pins , the zooming cannot
respond at all when the switch is off and the control is back to the
main function which controls the zooming. I have checked the logic
of the program but cannot find any fault. Can any one provide me
with some help?
Thanks!
I am written a program to control the zooming of a Sony video camera
of the model: FCB EX 470LP through the dedicated serial input pin.
The program works.
However, when I expand my program to pass a variable called stepsize
when is dependent on the zooming position to another basic stamp,
when a switch is on, through the i/o pins , the zooming cannot
respond at all when the switch is off and the control is back to the
main function which controls the zooming. I have checked the logic
of the program but cannot find any fault. Can any one provide me
with some help?
Thanks!